2032Es/2632Es/2646Es/3246Es Only - Oshkosh JLG 1930ES Service Maintenance Manual

2032ES/2632ES/2646ES/3246ES Only

BE SURE TO PULL THE BATTERY DISCONNECT ANYTIME WORK IS
BEING PERFORMED ON THE DRIVE MOTORS OR DRIVE MOTOR
CABLING.
1. Orient the drive cables going back towards the
rear of the machine. Loop the cables forward
towards the front of the machine then up and
back. Place the Green Clamp on the clamping ring
as shown below.
2. Obtain the Cable Clamp and hardware.
1. Bolt, Washers, and Nut
2. Cable Clamp
3. Bolt the Green Clamp onto the backside of the
frame using the the back hole drilled in step #4.
The roll pins inserted in the front-most holes act as
a stop to prevent the clamp from turning.
3121656
CAUTION
SECTION 3 - CHASSIS & SCISSOR ARMS
1. Drive Cable
2. Roll Pin
NOTE: When bolting the green clamp onto the frame, place
the larger washer against the clamp on the outside
of the clamp.
4. Connect the drive motor cables to the power mod-
ule..
5. Tuck all wires into the power module compart-
ment and install cover.
6. Reconnect battery cable plug. Power up machine
and operate the drive function to ensure drive
motors operate properly.
3. Cable Clamp
3-19