3.12 GROUND CONTROL STATION
NOTE: Anytime the ground control box is removed, the tilt
sensor must be re-calibrated. Refer to Section 5.3, Tilt
Sensor Calibration to re calibrate the tilt.
Box Disassembly
1. Disconnect the batteries.
2. Remove the three bolts at the bottom of the
ground control station.
3. Remove the four bolts where the control cable
enters into the control box.
4. Remove plug and place control box face down on
a suitable work bench.
3121656
SECTION 3 - CHASSIS & SCISSOR ARMS
.
5. Remove the six bolts at the back of the ground
control and separate.
3-37