SECTION 3 - CHASSIS & SCISSOR ARMS
Tilt Sensor Replacement
2
1
1. Ground Control Station
2. Tilt Sensor (JLG P/N 4000021 or
1001114936)
Figure 3-45. Tilt Sensor Location
Tilt Sensor Removal:
1. Disconnect the batteries.
2. Open the Ground Control Station to gain access to
the Tilt Sensor Assembly. (refer to prior mentioned
procedures)
3. Remove the four Screws (3), to remove the Tilt Sen-
sor (1) and Sensor Mount (2) from the Ground Con-
trol Box.
4. The Tilt Sensor (1) can be removed from the Sensor
Mount (2) by removing the three Screws (4).
NOTE: Follow the above procedures in reverse order when
installing the tilt sensor assembly. After installing, be
sure to calibrate the tilt sensor (refer to Section 5.3,
Tilt Sensor Calibration).
3-38
4
3
2
1. Tilt Sensor
2. Sensor Mount
3. Screw, 3.5 x 0.6 x 16 LG
4. Screw, 3.5 x 0.6 x 10 LG
Figure 3-46. Tilt Sensor Removal
Table 3-3. Tilt Sensor Harness
Wire Color
Function
Red
VCC
White
CANH
Green
CANL
Black
Ground
1
Connector Pin
1
2
3
4
3121656