Drive Motor Cable Routing; 1930Es Only - Oshkosh JLG 1930ES Service Maintenance Manual

SECTION 3 - CHASSIS & SCISSOR ARMS
3.4

DRIVE MOTOR CABLE ROUTING

1930ES Only

BE SURE TO PULL THE BATTERY DISCONNECT ANYTIME WORK IS
BEING PERFORMED ON THE DRIVE MOTORS OR DRIVE MOTOR
CABLING.
1. Orient the drive cables going back towards the
rear of the machine as shown below.
2. Loop the cables forward towards the front of the
machine then up and back so that the clamping
rings on the cables are aligned together.
3. Obtain the Cable Clamp and hardware.
1. Cable Clamp
2. Spacer Plate
3-18
CAUTION
3. Capscrew, Washers, and
Nut
4. Place the Green Clamp on the clamping rings as
shown below.
5. Bolt the clamp onto the underside of the frame.
a. The Spacer goes between the frame and the
Clamp.
b. Place the Larger Washer against the clamp.
6. Connect the drive motor cables to the power mod-
ule.
7. Tuck all wires into the power module compart-
ment and install cover.
1
3
1. Drive Cables
2. Cable Clamp
3. Spacer Plate
8. Reconnect battery cable plug. Power up machine
and operate the drive function to ensure drive
motors operate properly.
1
2
3121656