Table of Contents
Advertisement
work piece and work area set up
1.
Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2.
Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
3.
Secure loose work pieces using a
vise or clamps (not included) to pre-
vent movement while working.
4.
There must not be hazardous ob-
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
5.
You must use personal safety equip-
ment including, but not limited to,
ANSI-approved eye and hearing pro-
tection, as well as heavy work gloves.
6.
Before beginning work, provide for
sparks and debris that will fly off the
work surface.
reV 09f
SKU 98107
For technical questions, please call 1-800-444-3353.
general Operating instructions
Grip the tool firmly in both
hands.
1.
Press the Switch down and forward
to start the tool.
2.
Allow the tool to come up to full
speed before touching the work ma-
terial.
3.
Apply the wheel to the work mate-
rial, allowing the tool to operate at
full speed. If the tool bogs down, use
lighter pressure.
4.
To create a smoother surface, keep
the tool moving over the work sur-
face.
5.
Pull the Switch back to stop the tool.
6.
Allow the tool to come to a complete
stop before setting it down.
7.
To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children's reach.
tO preVent
seriOus injurY:
Page 15
Advertisement
Table of Contents
