Table of Contents
Advertisement
proved for the specific hazards in the
work area.
4.
power tool use and care
a.
do not force the power tool. use
the correct power tool for your ap-
plication. The correct power tool will
do the job better and safer at the rate
for which it was designed.
b.
do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
c.
disconnect the plug from the
power source and/or the battery
pack from the power tool before
making any adjustments, chang-
ing accessories, or storing power
tools. Such preventive safety mea-
sures reduce the risk of starting the
power tool accidentally.
d.
store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper-
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
e.
Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. if dam-
aged, have the power tool repaired
before use. Many accidents are
caused by poorly maintained power
tools.
f.
Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
SKU 98107
For technical questions, please call 1-800-444-3353.
g.
use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result
in a hazardous situation.
5.
service
a.
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
grinding, sanding or wire
Brushing Operation safety
warnings
1.
this power tool is intended to
function as a grinder, sander or
wire brushing tool. read all safety
warnings, instructions, illustra-
tions and specifications provided
with this power tool. Failure to fol-
low all instructions listed below may
result in electric shock, fire and/or
serious injury.
2.
Operations such as polishing or
cutting-off are not recommended
to be performed with this power
tool. Operations for which the power
tool was not designed may create a
hazard and cause personal injury.
3.
do not use accessories which
are not specifically designed and
recommended by the tool manu-
facturer. Just because the accessory
can be attached to your power tool, it
does not assure safe operation.
4.
the rated speed of the accessory
must be at least equal to the maxi-
Page 5
Advertisement
Table of Contents
