Dahua DH-XVR5416L-X User Manual page 252

Step 3 Click Apply to complete the settings.
After the Device is connected to a Wi-Fi hotspot, in the Wi-Fi Working Info area, the
current hotspot, IP address, subnet mask, and default gateway are displayed.
5.15.1.4 Configuring 3G/4G Settings
You can connect a wireless 3G/4G module to the USB port of the Device and then access the
Device with the IP address provided by the module.
Not all models support this function.
Step 1 Connect the wireless 3G/4G module to the USB port of the Device.
Step 2 Select Main Menu > NETWORK > 3G/4G.
The 3G/4G interface is displayed, see Figure 5-200.
The 3G/4G interface is consisted of three areas:
Area 1: Displays the signal strength.

Area 2: Displays the module configurations.

Area 3: Displays the connection state.

The information of Area 2 will display after the 3G/4G module is connected; while the
information of Area 1 and Area 3 will display only after the 3G/4G function is enabled.
Step 3 The Device starts identifying the wireless module and displays the recognized
information for the parameters in Area 2. See Table 5-61.
Parameter
Ethernet Card
Figure 5-200
Description
Displays the name of Ethernet card.
Local Configurations 236