Table of Contents
Advertisement
Quick Links
IMPORTANT!
Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written notifi cation.
A Crane Co. Company
420 Third Street
Piqua, Ohio 45356
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
Manual Index
BARNES
BARNES
INSTALLATION MANUAL
Submersible Sump Pump
Series: BP25
1/4 HP, 3450 RPM, 60 Hz.
83 West Drive, Bramton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
®
DISCONTINUED
Parts may
NOT be available
Form No. 101716A-Rev. B
Advertisement
Table of Contents
Related Manuals for Barnes BP25VF
Summary of Contents for Barnes BP25VF
- Page 1 Manual Index BARNES BARNES ® INSTALLATION MANUAL Submersible Sump Pump Series: BP25 1/4 HP, 3450 RPM, 60 Hz. DISCONTINUED Parts may NOT be available IMPORTANT! Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur.
-
Page 2: Safety First
Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Crane Pumps & Systems, Inc. 2003, 2/06 Alteration Rights Reserved... -
Page 3: Section: A - Pump Specifications
BP25A ..... Wide Angle, Mechanical, 10 Ft. (3m) SQUARE RINGS ....Buna-N Cord HARDWARE ....... 300 Series Stainless Steel BP25VF ..Vertical Float, PVC, Snap Action, PAINT ........Air dry enamel 10 Ft. (3m) cord SEAL Design ..... Single Mechanical, Oil Filled MINIMUM SUMP DIA: Material ... -
Page 4: Section B: General Information
B-4) Service Centers: For the location of the nearest Barnes Service Center, check your Barnes representative or Crane Pumps & Systems, Inc., Service Department in Piqua, Ohio, telephone (937) 778-8947 or Crane Pumps &... - Page 5 PUMP CYCLE OR RUN IF AN OVERLOAD CONDITION OCCURS ! MODEL PART NO VOLT/PH NEMA FULL CORD CORD CORD (Nom) START LOAD LENGTH SIZE TYPE CODE AMPS BP25A 100943 115/1 3450 10 ft. (3m) 16/3 BP25VF 100944 115/1 3450 10 ft. (3m) 16/3...
- Page 6 SECTION: E WARRANTY REPAIR E-2 Model Number: This designation consists of numbers and letters which E-1) Information Needed: represents the horsepower, motor phase and voltage, and ALWAYS furnish the following information: pump design. This number is used for ordering and obtain- ing information.
- Page 7 60 Hz Testing is performed with water, specifi c gravity of 1.0 @ 68° F, other fl uids may vary performance...
- Page 8 Notes...
-
Page 9: Troubleshooting
TROUBLE SHOOTING CAUTION ! Always disconnect the pump from the electrical power source before handling. If the system fails to operate properly, carefully read instructions and perform maintenance recommendations. If operating problems persist, the following chart may be of assistance in identifying and correcting them: MATCH “CAUSE”... -
Page 10: Returned Goods
IMPORTANT! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and return to Crane Pumps & Systems, Inc. Warranty Service Group If you have a claim under the provision of the warranty, contact your local Crane Pumps &... -
Page 11: Warranty Registration
IMPORTANT! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and return to Crane Pumps & Systems, Inc. Warranty Service Group If you have a claim under the provision of the warranty, contact your local Crane Pumps &... - Page 12 FOLD HERE AND TAPE, DO NOT STAPLE PLACE STAMP HERE CRANE PUMPS & SYSTEMS, INC. WARRANTY SERVICE GROUP 420 THIRD STREET PIQUA, OHIO 45356 - U.S.A.