Table of Contents
Advertisement
AP60C Hardware Guide
This illustration shows the USB, Micro USB and Reset buttons, which are located behind waterproof screw caps.
The pin-to-signal mapping for the Console port is shown below:
Pin
1
2
3
4
5
USB Port
AP460C devices have a standard USB port that you can use to connect USB-based beacons (iBeacon, for example) and IoT (Internet of Things)
devices. To access the port, remove the gland cap screw.
Reset Button
The Reset button is located behind the same waterproof screw cap as the micro USB port. Use the Reset button to reset the device or restore the
factory default settings.
To prevent the reset button from resetting the configuration, enter this command:
no reset-button reset-config-enable
When this command is enabled, pressing the button for 5 seconds will still reboot the AP, but pressing it for more than 10 seconds will not reset its
configuration.
Hardware Specifications
The following sections list radio, device, power, and environmental specifications for the AP460C.
Interfaces
100/1000/2500 Mbps auto-negotiation RJ45 Ethernet PoE port
l
10/100/1000 Mbps auto-negotiation RJ45 Ethernet port
l
AP460C Hardware Guide
Definition
NC
RxD (input to AP)
TxD (output to terminal)
Signal (GND)
Signal (GND)
8
8
Advertisement
Table of Contents
