JAI LQ-401CL User Manual page 25

Fig. 22 Setting screen for lateral chromatic aberration
Setting procedure:
Please use the following steps.
1. Chromatic Aberration Enable
2. Select Lens 1, 2 or 3
3. Set the left side pixel
4. Set the area
5. Set the second block pixel
6. Set the third block pixel
Enable :
Lens 1,2,3 :
Change name :
Left side pixel :
LQ-401CL
Set chromatic aberration function ON or OFF.
Command MAV=0(OFF) and MAV=1(ON).
Select a data set to use. Data for three lenses can be stored.
Instead of Lens 1, 2 and 3, specific names such as 28mm can be
displayed. Max. 16 alpha-numeric characters can be used.
Specifies by how many pixels the left edge of the image should
be shifted. The maximum value is 3 pixels. A negative value
extends the image by 1, 2 or 3 pixels. A positive value, narrows
the image.
Values to set are L3,L2,L1,R1,R2 and R3.
L3 says to shift 3 pixels to the left and R3 says to shift 3 pixels to the
right.
In case of Red, CABLR=[User Lens],[Shift value]
In case of Blue, CABLB=[User Lens],[Shift value]
In case of NIR, CABLIR=[User Lens],[Shift value]
The range of the shift value is -3 to +3.
24