Table; Installing Guard - Grizzly G4185 Instruction Manual

Table

The Model G4185 has a 15
table with dovetailed miter gauge slots. To install
the table:
1. Loosen the bolts that come already insert-
ed in the threaded holes on the underside
of the table.
2. Center the table and start retightening the
bolts, one at a time.
3. Tighten the bolts securely and make sure
the table is in the desired position. See
Figure 7.
Figure 7. Tightening the table bolts.
-12-
3 ⁄ " wide by 9 3 ⁄ " deep
4 4

Installing Guard

The Model G4185 comes with a sheetmetal guard
that helps keep hands away from moving parts.
This guard must be in place during operation of
the machine.
1. Remove the Phillips
are in the machine at the guard mounting
position.
2. Place the guard and fasten screws on one
side, leaving screws slightly loose.
3. Insert screws on the other side and tight-
en all screws fully. See Figure 8.
Figure 8. Tightening guard screws.
Model G4185 Horizontal Boring Machine
®
head screws that