Unpacking; Contents Of The Shipping Container - Jet ZH Series Operation And Maintenance Instructions

7.0 Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Lathe is
set up and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for set up, maintenance and safety
instructions.

Contents of the Shipping Container

(Refer to Figure 3)
1 Lathe
2 Steady Rests (mounted on Lathe)
1 Follow Rest (mounted on Lathe)
1 Three Jaw Scroll Chuck, 12-25/32"
(mounted on Lathe) – A
1 Drive Plate – B
1 Four Jaw Independent Chuck, 15-23/32" – C
1 Face Plate, 24-25/32" (with 6 dogs) – D
1 Round Nut Spanner, 170-210 mm – E
4 Change Gears – 63T, 69T, 78T, 90T – F
NOTE: Optional accessories are available for JET Lathes, such as Taper Attachment, Collet Closer and
Digital Read Out. Contact your dealer or Walter Meier (Manufacturing) Inc., for more information.
Figure 3
ZH Series Lathes – Contents of Shipping Container
1 Tool Box, containing the following:
1 Morse Reduction Sleeve – G
1 Live Center, MT-5 – H
1 Dead Center, MT-5 – I
2 Drive Pins – J
1 Cam Wrench – K
1 Chuck Wrench – L
1 Tool Post Wrench – M
1 Gap Bridge Pin Driver – N
1 Drift Key – O
1 Round Nut Spanner (45-52 mm) – P
1 Hex Key Set (6,8,10,12 mm) – Q
3 Fuses (2A,3A,4A) – R
6 Leveling Bolts with Hex Nuts – S
(qty. 8 for GH-26120ZH)
6 Leveling Pads – T
(qty. 8 for GH-26120ZH)
1 Flat Blade Screwdriver – U
1 Cross Point Screwdriver – V
2 Open End Wrenches (17/19,19/22) – W
1 White Touch-up Paint Can – X
1 Oil Gun – Y
1 Operating Instructions Manual
1 Parts List Manual
1 Warranty Card
1 Test Record
1 Packing List
11