Unpacking; Contents Of Shipping Container - Jet GH-1440ZX Operation And Maintenance Instructions

7.0 Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Lathe is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.

7.1 Contents of shipping container

1 Lathe
1 Steady Rest (mounted on Lathe)
1 Follow Rest (mounted on Lathe)
1 10" Three Jaw Chuck (mounted on Lathe)
1 Face Plate (12" Face Plate for 14" & 16"
lathes; 16" Face Plate for 18" & 22" lathes)
1 Tool Box containing:
1
1
1
1
6
2
6
1
1
1
1
1
1
1
1
2
1
4
3
1
1
1
1
1
1
1
1
1
Figure 3 - Contents of tool box
12
Open End Wrench Set
Hex Wrench Set
Morse Reduction Sleeve
Center
Leveling Bolts with Hex Nuts
Hex Screws with Washers
Leveling Pads
Flat Blade Screwdriver
Cross Point Screwdriver
Chuck Wrench
Cam Wrench
Adjustable Wrench
Round Nut Wrench
Oil Gun
Cross Feed Handle (not shown)
Shear Pins
Paint Can
Tool Holder
Sliding Sleeve（for 14" lathes ）
Indicate Bulb
Key for Cam Locks
Gear
Gap Bridge Pin Driver
Live Center (MT4 for 14" & 16" lathes;
MT5 for 18" & 22" lathes)
Operating Instructions Manual
Parts List Manual
Test Record
Warranty Card