LifeSpan TR1200iT Owner's Manual page 15

Step 7: Tighten Console Assembly
A. Make sure the console and the cup holders are fitting properly on the
Mounting Bracket.
B. The Mounting Bracket may have rotated a little during assembly. If needed,
slowly rotate the console assembly forward until the cup holders align and
rest on the handlebars.
C. Tighten the four M8 x 15L Bolts(15) and M8 Washers(16) under both sides of
the console tube.
B
Step 8: Remove
Shipping Strap
A. Cut plastic shipping
strap holding deck
frame to base.
WARNING:
up and carry it from this position once this strap is cut. The treadmill
should be folded and rolled to the new location or folded and carried to
Rotate
and align
top of cup
holder with
handlebar if
needed
To avoid personal injury, never attempt to pick the treadmill
the new location.
Assembling Your Treadmill
16
15
M8x 15L
(x4)
C
Pre-
installed,
just tighten
M8 Washer
(x4)
5mm Allen
Wrench w/
Phillips
17