Switching The Device Off Completely / Hard Reset - Medion GoPal E3132 Operating Instructions Manual

Switching the Device off Completely / Hard Reset

Attention!
A hard reset will delete all data in the temporary memory.
Your navigation system will normally be in the Standby Mode, if you have switched it off
by pressing the on/off button briefly. In addition, the system can be switched off com-
pletely; the consumption of energy can be kept as low as possible through this. All the
data in the temporary memory will be lost if the device is switched off completely (hard reset).
To switch your navigation system off completely:
1. Press the Reset button when the device is switched on. The device will switch off.
2. Press the ON/OFF switch to switch the device on.
A reinstallation will not be necessary after a hard reset if your device has already been
equipped with the basic data of the navigation software in the permanent memory.
You will be able switch the Main switch on and off briefly as an alternative, if the device is
not connected to a charging cable. Then start the device with the On/Off switch.
- 23 -