Initial Set Up; Charging The Battery - Medion GoPal E3132 Operating Instructions Manual

Initial Set up

The following is a step by step guide to assist in the initial Set-up of the navigation system.
Start by removing the protective plastic from the display.
I. Charging the Battery
The battery of your navigation system can be charged in the following ways:

Using the supplied car adapter or

using a suitable USB cable.
Attention!
It may be necessary to initially charge the battery for a considerable period
of time prior to commencing and running through the initial installation,
this is dependent on the level of charge held at the time by the internal
battery.
Attention!
The device can only be charged if the main switch (see P. 9) is set to ON.
Please observe the following notes relating to the battery:

The charging status display LED will flash orange until the navigation system is
charged. If possible, do not interrupt the charging process until the
battery is fully charged. This may take a few hours. The charging status LED will
shine constant green if the battery has a high level of charge. Leave the device
charging for 20 further minutes, to ensure the battery is fully charged.

The navigation system can be used during the charging process, but the power
supply must not be interrupted during initial set-up.

Leave the external power supply connected to the navigation system for around 24
hours, so that the backup battery also charges-up fully.

The external power supply can remain connected; this is recommended for conti-
nuous operation. However, the mains adapter (optional) must remain switched on
whenever it is connected to the navigation system.

Even after a power source has been connected to the device it may take several mi-
nutes until the device is once again ready to operate again, this occurs if the charg-
ing state of the battery is exceptionally low. The battery will continue to be charged
if the power supply is connected and the device is switched off.

The Reset button can be pressed without the charging process being interrupted af-
terwards if the Main switch is set to ON and the device has not been switched on,
when a charging cable is connected.
- 11 -