Switching The Device Off Completely / Hard Reset - Medion Navigation Unit Operating Instructions Manual

Switching the Device off Completely / Hard Reset

Attention!
A hard reset will delete all data in the temporary memory.
Your navigation system will normally be in the Standby Mode, if you have switched it off
by pressing the on/off button briefly. In addition, the system can be switched off com-
pletely; the consumption of energy can be kept as low as possible through this. All the
data in the temporary memory will be lost if the device is switched off completely (hard reset).
To switch your navigation system off completely:
1. Push the main switch to the position OFF to swich the device off.
2. Push the main switch to the position ON again to carry out the Hard Reset.
A reinstallation will not be necessary after a hard reset if your device has already been
equipped with the basic data of the navigation software in the permanent memory at the
factory.
UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
- 27 -