Wiring The Terminal Strip; Figure 2.13 - Jumper J17 Settings For Analog Outputs - Reliance electric 2V4160 Hardware Installation And Troubleshooting Manual

Step 3. Verify that the DC bus voltage is zero by following the procedure in section
Step 4. Locate jumper J17 on the Regulator board. Refer to figures 2.9, 2.10, and
Step 5. Locate pin 1 on jumper J17. Move the jumper to the desired setting as shown
Step 6. Reattach the cover. On 200-400 HP drives, close the outer cabinet door.
Step 7. Reapply input power.
Step 8. Verify that parameter P.012 is set correctly for either speed or current.

2.8.2 Wiring the Terminal Strip

The terminal strip on the Regulator board provides terminals for connecting customer
I/O devices. See figures 2.9, 2.10, 2.11, and 2.14. The following terminals are
provided:
•
•
•
•
•
•
•
About the Drive
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
9.3.
2.11.
in figure 2.13.
Voltage Output Option
Pins 2-3
10 VDC
J17
(default)
Figure 2.13 – Jumper J17 Settings for Analog Outputs
Terminals 1-3: RS-232 connections
Terminals 4-9: encoder connections
Terminals 10-11: analog output connections
Terminals 12-15: analog speed/torque reference connections
Terminals 16-25: 24V DC digital input connections
Terminals 26-27: snubber resistor braking control connections
(1-10 HP Regulator boards only) for older Snubber Resistor Braking Kits
(for example, the M/N 2DB4010 series)
Terminals 28-31: status relay connections
Current Output Option
Pins 1-2
4-20 mA
J17
2-17