Table of Contents
Advertisement
Terminal #
Notes: The output of this terminal is either 0-10 VDC or 4-20 mA as determined by the
setting of jumper J17 on the Regulator board. The analog output must also be
programmed via parameter P.012 for an indication of speed and direction or percent of
torque.
Terminal #
Notes: The analog speed/torque (P.008/U.000) reference is either +/-10 VDC or
+/-20 mA, as determined by the setting of jumper J4 on the Regulator board. The
analog reference can be adjusted using parameters P.009, P.010, and P.011.
Refer to Appendix G in the GV3000/SE Software Start-Up and Reference manual for
more information about the analog input.
.
Terminal #
Notes: When a user-installed function loss input, a coast-to-stop pushbutton, or another
external interlock is installed, the factory-installed jumper connecting terminals 16 and
20 (or 16A and 20A) must be removed so that a contact, when open, will stop the drive.
Terminals 17, 18, and 19 (remote control inputs 8, 7, and 6) are programmed using
parameters P.007, P.008, and P.031 through P.038. Factory default settings are shown
here in parentheses. Refer to the GV3000/SE Software Start-Up and Reference
manual for more information.
7-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 7.3 – Analog Output Connections (Terminals 10 and 11)
10
Analog Meter Output
11
Regulator Common
Table 7.4 – Analog Speed/Torque Reference Connections (Terminals 12-15)
12
Isolated Reference Voltage
13
VDC Speed/Torque Reference
14
mA Speed/Torque Reference
15
Isolated Reference Common
Table 7.5 – Digital Input Connections (Terminals 16-25)
16
+24 VDC (Current Limited) (For remote control digital inputs only)
17
Digital Input 8 (Remote/Local) - Programmable
18
Digital Input 7 (Ramp1/Ramp2) - Programmable
19
Digital Input 6 (Forward/Reverse) - Programmable
20
Function Loss
21
Run/Jog
22
Reset
23
Stop
24
Start
25
+24 VDC Common
Signal
Signal
Signal
GV3000/SE AC Drive Hardware Reference, Version 6.06
Advertisement
Table of Contents
