Table of Contents
Advertisement
Add a RAM Module
Follow the steps below to install, check, or remove a RAM module.
To install a RAM module:
1 Shut down your DiskStation. Disconnect all cables from your DiskStation to prevent any possible damage.
2 Remove the 2 screws on the right side of the back panel, and then pull the side cover in the direction as
illustrated below. Place the screws and the cover aside.
Important:
When you remove the side cover, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you insert or remove a RAM module.
3 Insert a new RAM module into the memory slot:
a Align the notch on the gold edge of the module with the memory slot key (i.e. the notch in the memory slot).
b Firmly push the module into the slot at a 45 degree angle. The RAM module is properly inserted when you
hear the retaining clips snap into place.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
