Table of Contents
Advertisement
Add a RAM Module on DiskStation
The optional Synology DDR3 RAM module is designed for DiskStation memory expansion. Follow the steps
below to install, check, or remove a RAM module on your DiskStation.
To install the RAM module:
1 Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible
damage.
2 Remove the inner panel:
a Remove the 4 screws on the back of DiskStation, and then pull the top and side cover. Place both covers to
the side.
b Remove the 7 screws that secure the inner panel.
Note:
When you remove the case, you expose sensitive internal components. Avoid touching anything other than the
memory assembly when you remove or add memory.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
