Table of Contents
Advertisement
Add a RAM Module on DiskStation
The optional Synology DDR4 RAM module is designed for DiskStation memory expansion. Follow the steps
below to install, check, or remove a RAM module on your DiskStation.
To install the RAM module:
1 Press and hold the power button until you hear a beep sound to shut down your DiskStation. Disconnect all
cables from your DiskStation to prevent any possible damage.
2 The RAM modules are located at the bottom of DS1618+.
3 Remove the 2 screws that secure the bottom lid. Lift off the lid and place it to the side. You will see one 4GB
module pre-installed.
Important:
When you remove the lid, you expose sensitive internal components. Avoid touching anything other than
the memory assembly when you remove or add memory.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
