Add A Network Interface Card - Synology DiskStation DS3617xs Hardware Installation Manual

Add a Network Interface Card

Your DiskStation has a PCI Express expansion slot which allows you to install 10GbE or Gigabit network interface
card for LAN port expansion.
with a short bracket before installing the card into your DiskStation.
To replace a long bracket with a short one:
1 Remove the 2 screws from the long bracket of your network interface card, and then remove the bracket.
2 Replace the long bracket with a short one, and tighten the 2 screws to secure the short bracket.
To install a network interface card:
1 Press and hold the power button until you hear a beep sound to shut down your DiskStation. Disconnect all
cables from your DiskStation to prevent any possible damage.
2 Remove the 2 screws on the top of the back panel, and then pull the top cover in the direction as illustrated
below.
1
For more information about supported 10GbE or Gigabit network interface cards, please visit www.synology.com.
12 Chapter 2: Hardware Setup
You need to replace the long bracket (suited for PC) of your network interface card
1