Table of Contents
Advertisement
Add a RAM Module on DiskStation
The optional Synology DDR4 RAM module is designed for DiskStation memory expansion. Follow the steps
below to install, check, or remove a RAM module on your DiskStation.
To install the RAM module:
1 Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible
damages.
2 The RAM modules are located at the bottom of DS1819+.
3 Remove the 2 screws that secure the bottom panel. Lift off the panel and place it to the side. You will see there
is one pre-installed 4G RAM module.
Important:
When you remove the panel, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you remove or add memory.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
