Table of Contents
Advertisement
Add a RAM Module on RackStation
Synology offers 2GB RAM modules which allow you to expand the memory capacity of your RackStation. To
install, check, or remove your RAM module, please follow the steps below.
Install a RAM Module
1 Shut down your RackStation, and disconnect all connected cables to prevent any possible damage.
Important:
Before installing the RAM module, please wait for at least 30 seconds after detaching the power
cord(s) from the RackStation to ensure complete discharge. Also, please remove any static electricity before
installation by touching water pipes, a metal conduit, or another person to get rid of excess charge and avoid
damaging the motherboard, peripherals, and other components.
2 Slide the latches on the sides and lift to remove the fan cover from your RackStation.
3 To remove the screws securing the top cover, follow the steps below:
a Remove the two screws illustrated below.
9 Chapter 2: Hardware Setup
Advertisement
Table of Contents
