Add A Ram Module On Synology Nas - Synology RackStation RS820RP+ Hardware Installation Manual

Add a RAM Module on Synology NAS

The optional Synology RAM module is designed for Synology NAS memory expansion. Follow the steps below to
install, check, or remove a RAM module on your RS820+ / RS820RP+.
To install the RAM module:
1 Shut down your RS820+ / RS820RP+. Disconnect all connected cables to prevent any possible damage.
2 Remove the top cover:
a Loosen the four screws on the top cover of the RS820+ / RS820RP+ with a screwdriver. Respective screw
position is indicated above.
b Push forward the top cover to the front-end of your RS820+ / RS820RP+, as indicated above.
Note: When you remove the top cover, you expose sensitive internal components. Avoid touching anything other than
the memory assembly when you remove or add memory.
RS820+ / RS820RP+
Important:
Note:
1. When memory capacity is changed, the device will perform a memory check upon the next start up. This will
prolong the start up time by up to ten minutes. This behavior is normal and will only occur once.
2. Synology will not provide complete product warranty or technical support if non-Synology RAM modules are used
for memory upgrade.
12 Chapter 2: Hardware Setup
does not support ECC, regardless the expand memory being ECC or non-ECC.