Table of Contents
Advertisement
Network Speed Dome User Manual
(5) Click
Configuring PPPoE Settings
Purpose:
If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function.
Steps:
1. Enter the PPPoE Settings interface:
Configuration > Network > Basic Settings > PPPoE
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
The User Name and Password should be assigned by your ISP.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (Using a
minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers, and special characters.) in
order to increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
4. Click
Configuring Port Settings
Purpose:
If there is a router and you want to access the speed dome through Wide Area
www.a1securitycameras.com email: sales@a1securitycameras.com
to save the settings.
Figure 6-7 PPPoE Settings
to save and exit the interface.
Available from A1 Security Cameras
86
Advertisement
Table of Contents
