Table of Contents
Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
A.
Connect Tray (C) to one of the Uprights (A) using:
Two 2 (M10x102 carriage head bolt)
Two 3 (M10 curved washers)
Two 5 (M10 nylon nut)
B.
Connect Top Frame (B) to the same Upright (A) using:
Two 1 (M10x55 hex head bolt)
Two 4 (M10 washer)
C.
Carefully lay the unit on the assembled side.
D.
Connect Tray (C) to remaining Upright (A) using:
Two 2 (M10x102 carriage head bolt)
Two 3 (M10 curved washers)
Two 5 (M10 nylon nut)
E.
Connect Top Frame (B) to the same Upright (A) using:
Two 1 (M10x55 hex head bolt)
Two 4 (M10 washer)
F.
Set the unit upright.
G.
Make sure the rack is on a flat surface. Tighten all assembled hardware.
H.
Insert End Caps (7) onto Upright (A).
I.
Congratulations!! You have completed the assembly of the GFR500.
DO NOT tighten hardware until the end of this step.
Some components may be pre-installed.
6
Advertisement
Table of Contents
