Selecting Data - Omron SmartSlice GRT1-OD4G-1 Operation Manual

Overview of the Temperature Input Units
6-1-6

Selecting Data

160
Analog processing is performed according to the following flowchart.
Input
Moving
average
A
Top/Valley
Peak/Bottom
Peak Top
value 2 value 4
Bottom Valley
value 3 value 5
Hold Flag
Data Flow
Selection
After performing math operations, select one of the six resulting values to allo-
cate as outputs to the Master, from the temperature input value, peak value,
bottom value, top value, valley value, and rate of change. The selected data is
referred to as "temperature data" and can be allocated for the Master individu-
ally or in combination with status flags. The data is selected using the Setting
Tool. Comparison operations with four alarm set values can be performed for
temperature data using the Comparator.
Scaling
Cumulated
Rate of change
value
Cumulated
Rate of change
value
value 6
Top/Valley detection timing
(allocated I/O data)
Conversion
Allocated
processing
I/O data
Section 6-1
A
Temperature
input value 1
Processing
results