DAVIS Vantage Pro2 Plus User Manual page 26

Selecting Units of Measure
Outside and Inside Temperature
1. Press TEMP to select outside temperature.
Temperature may be displayed in degrees Fahrenheit (ºF) or
Celsius (ºC). Temperatures can also be displayed in degrees or in
tenths of a degree.
2. Press TEMP again to select inside temperature.
Each consecutive press of TEMP displays temperature readings for any optional
temperature, temperature/humidity, soil temperature, soil moisture stations also
connected to your console. The order of the optional sensors readings display
depends on your station configuration. Temperatures for temperature stations
display, with soil temperature and moisture stations displaying consecutively.
Humidity
Press HUM to select outside humidity. Pressing HUM a second time
selects inside humidity. Humidity is displayed in percent relative humidity. Each
consecutive press of HUM displays humidity readings for any optional humidity,
leaf wetness, and leaf temperature stations also connected to your console. The
order of the optional sensors readings display depends on your station
configuration. Humidity readings for humidity stations display, with leaf wetness
and leaf temperature readings displaying consecutively.
Wind Chill
Press 2ND then press CHILL to select Wind Chill. Wind Chill
is displayed in either Fahrenheit (ºF) or Celsius (ºC) in whole
degrees.
The console uses the ten-minute average wind speed to calculate wind chill.
Dew Point
Press 2ND then press DEW to select Dew Point. Dew Point is
displayed in either Fahrenheit (ºF) or Celsius (ºC) in whole
degrees.
22
HUM IN
N
WIND
NW NE
TEMP OUT
W E
MPH
TEMP IN
SW SE
S
Last 24 hrs Every1 hr
DAIL Y RAIN
Vertical Scale: X10
Humidity, Pressure, Dew Point & Wind
HUM OUT
pm
HUM OUT BAR OMETER
F
hPa
HUM IN
F F
HEAT INDEX
RAIN YEAR
in
in
ST ATION NO.1
BAR OMETER
hPa
DEW POINT
F
CHILL
F
2
ND
2
ND
TEMP
DEW
HUM
CHILL
WIND
DEW
HUM