Screen 7: Time Zone - DAVIS Vantage Pro2 Plus User Manual

include latitude and longitude lines. You can also talk to the reference department of
your local library, call your local airport, or search on the Internet.
The more accurate you are, the better; however, a reasonable estimate will work.
1. Press the < and > keys to move between fields.
2. Press the + and - keys to change the settings up or down.
3. To select between SOUTH or NORTH, press 2ND and then UNITS.
4. Press DONE to move to the Longitude screen.
1. Press the < and > keys to move between fields.
2. Press the + and - keys to change the settings up or down.
3. To select the East or West Hemisphere, press 2ND, then UNITS.
4. Press DONE to move to the next screen.

Screen 7: Time Zone

The console is pre-programmed with a combination of US time zones and the
names of major cities representing time zones around the world. You can also
configure your time zone using the Universal Time Coordinate (UTC) offset.
Note: UTC offset measures the difference between the time in any time zone and a
standard time, set by convention as the time at the Royal Observatory in
Greenwich, England. Hayward, California, the home of Davis Instruments, observes
Pacific Standard Time. The UTC offset for Pacific Standard Time is -8:00, or eight
hours behind Universal Time (UTC). When it's 7:00 pm (1900 hours) UTC, it's 19 - 8
= 1100 hours, or 11:00 am in Hayward in winter. When daylight saving time is
observed, an hour is added to the offset time automatically. Use this function in
correlation with Screen 8, Daylight Saving Settings.
1. Press the + and - keys to cycle through time zones.
2. If your time zone is not shown, press 2ND then press the + and - keys to set
your UTC offset.
Screen 5: Latitude
Screen 6: Longitude
Screen 7: Time Zone
Setup Mode
15