Table of Contents
Advertisement
NOTE:
Slide the cover horizontally.
„
Put 2x AAA batteries in the compartment and make sure the polarity is correct.
„
Slide horizontally to close the cover.
„
Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
Please note the batteries' polarity to avoid short circuit.
„
When the battery's voltage is insufficient which affect the use range, you should replace it with
„
a new battery. Remove the batteries from the remote control unit if you do not intend to use it
for a long time.
Do not use different types of batteries (for example Manganese and Alkaline batteries) together.
„
Do not put the battery into fire, and charge or decompose the battery.
„
Please dispose batteries abide by relevant environmental protection regulation.
„
2.7 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote
„
control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote
„
control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit
„
by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not
„
work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections have been made properly, switch on your TV. Insert the main power plug into the
wall outlet, now the red LED light should light up. Press the q button on your remote control to wake
the TV up. The language and country selection will appear on the screen. Use t u to select the OSD
Language of your preference. Use pq to select the Country and use t u again to select the region you
are using this TV. This country/region selection is an important setting, it will set the time zone and will
try to sort region channels at first or in a specific order.
If all settings are made, confirm with OK on your remote control and follow the next steps.
On the next screen, you can select which tuner you like to use and which channels you'd like to search
for. Choose Tuner Type and by pressing t u you can choose between DTV, ATV or DTV + ATV (DTV to
search digital broadcasts; ATV to search analogue broadcasts). After you made your selection, press q to
proceed to Digital type. In this menu you can select which input source you would like to use:
DVB-S to receive satellite broadcasts (if you are equipped with a satellite dish)
„
DVB-T to receive terrestrial broadcasts (by using indoor or outdoor antenna)
„
DVB-C to receive cable broadcasts. (Connection to cable outlet box)
„
Then the next screen appears depending from the tuner selection you choose.
3.1 DVB-S/S2 installation
Satellite Setting
Pictures are only for reference. Actual items may differ.
7
Advertisement
Table of Contents
