Table of Contents
Advertisement
S
S
UPER
ERVER 5018D-LN4T User's Manual
BIOS Recovery
Close pins 2 and 3 of jumper JBR1 for
BIOS recovery. The default setting is on
pins 1 and 2 for normal operation. See
the table on the right for jumper settings.
BMC Enabled
JPB1 allows you to enable the BMC
(Baseboard Management Control) chip
and the onboard IPMI connection for
debugging purpose only. After the BMC
is disabled, IPMI health and remote
management functions are no longer
supported. See the table on the right for
jumper settings.
Note: Please aways keep BMC enabled
to make sure that the platform operates
reliably with the health monitor.
GbE LAN Ports Enable/Disable
Jumpers JPL1 and JPL2 are used to
enable or disable LAN ports 1 and 2,
respectively. Use JPL3 to enable or
disable LAN ports 3, 4, 5, and 6. See
the table on the right for jumper settings.
10GbE LAN Ports Enable/Disable
JPTG1 is used to enable or disable
10GbE support. See the table on the
right for jumper settings.
Pin#
Pins 1-2
Pins 2-3
Pin#
Pins 1-2
Pins 2-3
Pin#
Pins 1-2
Pins 2-3
10Gb Enable/Disable
Pin#
Pins 1-2
Pins 2-3
5-18
BIOS Recovery
Jumper Settings
Definition
Normal
BIOS Recovery
BMC Enabled
Jumper Settings
Definition
Enabled (Default)
Disabled
GbE LAN Enable
Jumper Settings
Definition
Enabled (Default)
Disabled
Jumper Settings
Definition
Enabled (Default)
Disabled
Advertisement
Table of Contents
