Voltage[:Dc]:Range; Voltage:nplc - HP E1326B User Manual

VOLTage[:DC]:RANGe?

Example

VOLTage:NPLC

Parameters
Comments
173 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VOLT:DC:RANG 0.9
READ?
enter statement
[SENSe:]VOLTage[:DC]:RANGe? [MIN | MAX]
numbers to the output buffer.
The present voltage range selected if
available with the
RANGe
selects the 0.91 V range, 1.0 V is the range returned.
The minimum voltage range available with the
(0.125 V) if is specified.
MIN
The maximum voltage range available with the
(300 V) if is specified.
MAX
Querying the Measurement Range
VOLT:DC:RANG 1.0
VOLT:DC:RANG?
enter statement
[SENSe:]VOLTage:NPLC <
(PLCs). Values are rounded up to the nearest number of PLCs shown in the
following table.
Parameter Name
< number >
• MIN
selects 0.0005 PLCs.
PLCs also sets the aperture time and the resolution. For example, 16 PLCs (60 Hz
line frequency) sets an aperture time of 267 ms. The corresponding resolution
depends on the function and range you select.
•
The VOLT:NPLC command overrides the results of previously executed
and
VOLTage:APERture
executed has priority).
!Range selected 1 V;
MAX resolution: 61.035 µV.
!Place multimeter in wait-for-trigger state and
make measurements;
send readings to output buffer.
!Enter readings into computer.
returns one of the following
or are not specified. Only the ranges
MIN MAX
command are returned. For example, if
VOLTage:DC:RANGe
VOLTage:DC:RANGe
!Select 1 V range.
!Query multimeter to return the present
range.
!Enter value into computer.
number sets the integration time in power line cycles
>
Parameter Type Range of Values
numeric 0.0005 | 0.005 | 0.125 | 1 | 16 |
MIN | MAX
selects 16 PLCs. Setting the integration time in
MAX
commands (the last command
VOLTage:RESolution
CONFigure
command
command
Default Units
PLCs
Chapter 5