Chapter 2. Configuring The Hp E1326B/E1411B Multimeter; About This Chapter; Installation Overview - HP E1326B User Manual

5 1/2 digit multimeter
Table of Contents

Advertisement

Configuring the HP E1326B/E1411B

About This Chapter

WARNING

Installation Overview

Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This chapter contains information on connecting input signals to the
multimeter using multiplexers and using the terminals on the multimeter's
faceplate. The main sections of the chapter are:
Installation Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 21
Input Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 28
Connecting Input Signals. . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 32
Carrier Cable Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 37
Additional Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 39
SHOCK HAZARD. Only service-trained personnel who are
aware of the hazards involved should install or configure the
multimeter. Remove all sources of power to the multimeter and
mainframe before removing the multimeter.
The maximum allowable input on the multimeter terminals is
300 V dc (450 V ac peak). Since the terminals are isolated from
the multimeter chassis, the potential between the terminals and
the chassis is equal to the value of the input signal.
As mentioned in the HP VXIbus Systems Installation and Getting Started
Guide, each plug-in module has a row of switches which set the module's
logical address. Based on this address, the system instrument within the
HP 75000 Series B mainframe and HP E1406A command module combines
the modules into virtual instruments. The instruments are programmed by a
computer using SCPI language or from a computer by writing commands
directly to the multimeter registers (see Appendix C).
This section shows the location of the multimeter's logical address switch
and shows how it is set. It also mentions considerations when installing the
multimeter in the mainframe.
Configuring the HP E1326B/E1411B Multimeter
Chapter 2
Multimeter
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

E1411b

Table of Contents