ZyXEL Communications VMG Series User Manual page 105

Figure 49 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM or
Ethernet-Bridge Mode)
The following table describes the fields in this screen.
Table 27 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM or
Ethernet-Bridge Mode)
LABEL DESCRIPTION
General Click this switch to enable or disable the interface. When the switch turns blue
enabled. Otherwise, it's not.
Name Enter a service name of the connection.
Type Select ADSL/VDSL over PTM as the interface that you want to configure. The Zyxel Device uses the
VDSL technology for data transmission over the DSL port.
Mode Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN This section is available when you select ADSL/VDSL over PTM in the Type field.
Click this switch to enable or disable VLAN on this WAN interface. When the switch turns blue
the function is enabled. Otherwise, it's not.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
If you select ADSL over ATM as the interface type, the following screen appears.
Chapter 6 Broadband
VMG/XMG Series User's Guide
105
, the function is
,