Table of Contents
Advertisement
30
www.aeg.com
10.3 Function Lock
This function prevents an accidental
change of the heating function. You can
activate it only when the appliance
operates.
1. Activate the appliance.
2. Set a heating function or setting.
3. Press
display shows: Function Lock.
4. Press
To deactivate the function, press
display shows a message. Press
and then
When you deactivate the
appliance, the function also
deactivates.
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of any symbol.
1. Activate the appliance.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
5. Press
display shows: Set + Go.
6. Press
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, an
acoustic signal sounds.
• Function Lock is on when
• The menu: Basic Settings
again and again until the
to confirm.
to confirm.
again and again until the
again and again until the
to confirm.
the heating function
operates.
lets you activate and
deactivate the function:
Set + Go.
10.5 Automatic Switch-off
For safety reasons the appliance turns off
automatically after some time if a heating
function operates and you do not
change any settings.
Temperature (°C)
30 - 115
120 - 195
200 - 230
. The
again
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a symbol during the
– if the appliance is deactivated and
) to start
10.7 Cooling fan
When the oven operates, the cooling fan
turns on automatically to keep the
surfaces of the oven cool. If you turn off
the oven, the cooling fan can continue to
operate until the oven cools down.
Switch-off time (h)
12.5
8.5
5.5
The Automatic switch-off
does not work with the
functions: Light, Food
Sensor, Duration, End Time.
night brightness (apart from ON /
OFF), the display goes back to
the day brightness mode for the
next 10 seconds.
you set the function: Minute
Minder. When the function ends,
the display goes back to the night
brightness.
Advertisement
Table of Contents
