Kenwood FPM810 Series Instructions Manual page 9

the speed control returned to the 'O' off position.
After processing the last weight will be displayed on the
screen when the speed control is returned to the 'O' off
position. Note: The weight of the lid will be included if the
display is not zeroed before switching on.
The weight of any additional ingredients added down the
feed tube whilst the processor is running will not be shown
on the display screen.
weighing tray
A removable weighing tray
is supplied for weighing
ingredients without the bowl or
blender.
To use, place the tray on top
of the power unit. Then follow
steps 2 to 5 under 'to use the
weighing function'.
To remove, just lift the tray off.
auto switch off
The display screen will turn off automatically if the same
weight reading is shown after 5 minutes.
The display screen can be turned off manually by pressing
and holding down the ON/ZERO button for a few seconds.
important
Do not overload by exceeding the maximum weighing
capacity of 3Kg. The display will show [0 – Ld] if the
weighing function is overloaded.
Do not subject the power unit to excessive force as this may
damage the weighing sensor.
Always place the processor on a dry flat surface prior to
weighing.
Do not move the power unit during operation of the
weighing function.
to use your thermoresist blender
1 Fit the sealing ring into the blade unit
seal is located correctly in the grooved area.
Leaking will occur if the seal is damaged or
incorrectly fitted.
2 Hold the underside of the blade unit
blades into the goblet - turn anti-clockwise until it clicks
Refer to the graphics on the underside of the blade unit as
follows:
- unlocked position
- locked position
The blender will not work if incorrectly
assembled.
3 Put your ingredients into the goblet.
4 Fit the lid to the goblet and push down to secure
filler cap.
5 Place the blender onto the power unit, and turn clockwise
to lock.
The appliance will not operate if the blender is
incorrectly fitted to the interlock.
6 Select Auto, or a speed (refer to the recommended speed
chart) or use the pulse control.
- ensuring the
and insert the
.
. Fit the
7
hints
When making mayonnaise, put all the ingredients, except
the oil, into the blender. Remove the filler cap. Then, with the
appliance running, add the oil slowly through the hole in the
lid.
Thick mixtures, e.g. pâtés and dips, may need scraping
down. If the mixture is difficult to process, add more liquid.
Ice crushing - operate the pulse in short bursts until crushed to
the desired consistency.
The processing of spices is not recommended as they may
damage the plastic parts.
The appliance will not work if the blender is incorrectly fitted.
To blend dry ingredients - cut into pieces, remove the filler
cap, then with the appliance running, drop the pieces down
one by one. Keep your hand over the opening. For best
results empty regularly.
Don't use the blender as a storage container. Keep it empty
before and after use.
Never blend more than 1.6 litres (2 pts 8 fl oz) - less for
frothy liquids like milkshakes.