Kenwood FPM810 Series Instructions Manual page 6

Appliances can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe
way and if they understand the hazards involved.
This appliance shall not be used by children. Keep the appliance and its
cord out of reach of children.
Only use the appliance for its intended domestic use. Kenwood will not
accept any liability if the appliance is subject to improper use, or failure to
comply with these instructions.
Misuse of your processor/blender can result in injury.
The maximum rating is based on the attachment that draws the greatest
load. Other attachments may draw less power.
Refer to the relevant section under "using the attachments" for additional
safety warnings for each individual attachment.
blender
SCALD RISK: Hot ingredients must be allowed to cool to room
temperature before placing in the goblet or before blending.
Always take care when handling the blade assembly and avoid touching
the cutting edge of the blades when cleaning.
Be careful if hot liquid is poured into the blender as it can be ejected out of
the appliance due to sudden steaming.
Only operate the blender with the lid in place.
Only use the goblet with the blade assembly supplied.
Never run the blender empty.
To ensure the long life of your blender, do not run it for longer than 60
seconds.
Smoothie recipes - never blend frozen ingredients that have formed a solid
mass during freezing, break it up before adding to the goblet.
The skirt on the base of the goblet is fitted during manufacture and no
attempt should be made to remove it.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimise the possibility of scalding when blending hot ingredients keep
hands and other exposed skin away from the lid to prevent possible burns.
The following precautions must be observed:
CAUTION: Blending very hot ingredients may result in hot
liquid and steam being forced suddenly past the lid or filler
cap .
We recommend that hot ingredients are allowed to cool
before blending.
NEVER exceed 1200mls/5 cups capacity if processing hot liquids, such
as soups (refer to the markings on the goblet).
4