Kenwood FPM810 Series Instructions Manual page 14

Problem
The processor will not operate.
Blender will not operate.
Processor stops or slows
during processing.
Weighing function
Display screen freezes on [- - - -].
Weight changed on display screen.
Power On light flashing rapidly.
Power On light flashing slowly.
Auto and Power On light flashing.
Blender leaking from blade assembly base. Seal missing.
Blender seal missing from blade unit when
removed from packaging.
Poor performance of tools/attachments.
troubleshooting guide
Cause
No Power.
No power/indicator light not lit.
Bowl not fitted to power unit correctly.
Bowl lid not locked on correctly.
Eco function operating.
Blender not locked on correctly.
Blender not assembled correctly.
Overload protection operated.
Processor overloaded or overheated during
operation.
Maximum capacity exceeded.
Quantity weighed too small.
Power unit moved during operation.
Normal operation.
The light will flash if the bowl, lid or blender are
not fitted to the power unit or not locked in
place correctly.
Normal operation.
Food processor left plugged in for over 30 minutes Press either the Auto Button or
without being operated and gone into Eco mode.
Normal operation.
The light will flash if the Auto selected but
interlocks not engaged.
Seal incorrectly fitted.
Seal damaged.
The seal is packed pre-fitted to the blade unit.
Refer to hints in relevant "using the attachment" section. Check attachments are
assembled correctly.
12
Solution
Check processor is plugged in.
Check bowl is located correctly
and the handle is situated
towards the right hand side.
Check that the lid interlock is
located correctly into the
handle area.
The processor will not
work if the bowl and lid
are fitted incorrectly.
Press either the Auto Button or
turn speed control on, then
return to 'O' to switch off Eco
function.
If none of the above check the
fuse/circuit breaker in your home.
The blender will not operate if
fitted incorrectly to the
interlock.
Check blade unit is fully
tightened into the goblet.
Switch off, unplug and allow
the appliance to cool down for
approximately 15 minutes.
Refer to the speed chart for
maximum capacities to
process.
Use teaspoon and tablespoon
measures for very small
quantities.
Do not move unit during use.
Zero the display before
weighing next ingredients.
Check interlocks are engaged
correctly.
turn speed control on and then
return to 'O' to switch off Eco
function.
Check interlocks are engaged
correctly or press the Auto
button to switch off the Auto
function.
Check seal is fitted correctly
and not damaged. To obtain a
replacement seal see "service &
customer care".
Unscrew goblet and check that
seal is fitted to blade unit.
To obtain a replacement seal
see "service & customer care".