Test I-7530 On Can Network (Only For Normal Mode) - ICP DAS USA I-7530-G CR User Manual

I-7530 rs-232/can converter

Hide thumbs Also See for I-7530-G CR:

Table of Contents

3.3

Test I-7530 on CAN network (Only for normal mode)

The following procedure will guide you to learning how to

transmit/receive CAN messages to/from other devices/PCs by using the I-

7530 converter. Note that users can only employ this test function for the

system if they are using the default communication parameters for the RS-

232 as provided above.

1. Set the Init/Normal switch to the Normal position, which is found at the

back of the I-7530 module.

2. Connect the I-7530's CAN port into the CAN network, which must at

least have one CAN device on the network.

3. Supply the 10~30 volts DC source into the I-7530 module through the

power terminal.

4. The ON LED on the I-7530 module will be turned on. That means the I-

7530 is working in the operation mode.

5. Run the I-7530 Utility software after there is a wire connection as shown

in Section 2.5.

6. Select the "Test" tab and click the "Connect" icon on the tool bar in the

I-7530 Utility to configure the PC COM port and Baud rate, which will be

used to connect to the COM port of the I-7530.

I-7530 RS-232/CAN Converter User's Manual (Version 2.5, Mar/2012) ------------- 19

Table of Contents