Related Manuals for Clarke Strong-Arm CTJ2250Q
Summary of Contents for Clarke Strong-Arm CTJ2250Q
- Page 1 QUICK LIFT HYDRAULIC JACK CTJ2250Q & QM MODEL NO: PART NO: 7623071 & 7623073 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC1117 - ISS 1...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Garage Jack. This manual covers the CTJ2250Q and the CTJ2250QM which is supplied in a blow moulded case. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
9. Do not try to lift more then the rated load for the jack. 10. Do not use the jack if an oil leak is apparent. Consult your Clarke dealer. 11. Consult the vehicle handbook to determine the correct lifting points. -
Page 4: Before Use
2. Inspect the jack for oil leaks or any other sign of damage. If in doubt, do not use. Should any defects be apparent, have the jack repaired by your Clarke dealer. 3. Check the piston for dirt, rust etc which can damage the piston and internal components. - Page 5 4. Place the operating lever in the jacking port and pump the operating lever to raise the saddle until it reaches the jacking point. 5. Check that there are no obstacles to prevent a clean lift, also, make sure that all personnel are well away from the area, before raising the vehicle. 6.
-
Page 6: Maintenance
• The oil should be almost level with the bottom of the filler hole. • Oil can be topped up using Clarke Hydraulic Oil (p/n 3050830 1 litre). 3. Bleed any air from the system as described below and replace the filler plug and cover plate. -
Page 7: Troubleshooting
Air in the hydraulic ram Bleed air as on page 6. Jack will not lower Return spring may be Return to your Clarke dealer for completely faulty. repair If any of these remedies fail to restore your jack, consult your Clarke dealer. -
Page 8: Component Parts - General Assembly
COMPONENT PARTS - GENERAL ASSEMBLY... - Page 9 COMPONENT PARTS - GENERAL ASSEMBLY Description No Description Washer Spring Washer Bolt Flat Washer Lower Hinge Pin Front Wheel Rear Pivot Pin Bush Lifting Arm Left Sideplate Circlip Circlip Plastic Lifting Handle Spindle Cover Plate Circlip Hydraulic Ram Assembly Lifting Saddle Return Spring Rotating Cup Spring Washer...
-
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY... - Page 11 USEFUL PRODUCTS IN THE CLARKE RANGE...