Related Manuals for Clarke Strong-Arm CTJ2500QLP
Summary of Contents for Clarke Strong-Arm CTJ2500QLP
- Page 1 2.5 TONNE TROLLEY JACK MODEL NO: CTJ2500QLP PART NO: 7621804 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC1020...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Garage Jack. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
9. DO NOT try to lift more than the rated load for the jack, (See “Specifications” on page 2.) 10. DO NOT use the jack if an oil leak is apparent. Consult your CLARKE dealer. 11. Consult the vehicle handbook to determine the correct lifting points. -
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY 1. Remove the retaining clip by pressing the handle yoke down- wards and pulling the clip away. 2. Loosen the bolt in the yoke until the lower handle can be inserted fully into the handle socket. • The lower handle has a groove which should engage with the bolt once it is re-tightened. -
Page 5: Operation
OPERATION This jack incorporates a twin piston pump with a ‘quick lift’ facility. This provides the user with a rapid raising operation for the unloaded jack. When the jack encounters a load (the vehicle to be raised), its distance raised per stroke reduces to provide a gradual and controllable lifting operation. -
Page 6: Maintenance
2. Remove the cover plate and the oil filler plug. • The oil should be almost level with the bottom of the oil filler hole. • It can be topped up using Clarke Hydraulic Oil (p/no 3050830 for 1 litre). -
Page 7: Troubleshooting
Purge the system as on p 6 Jack will not Return spring may be Return to your dealer for repair lower completely faulty If any of these remedies fail to restore your jack, consult your CLARKE dealer DECLARATION OF CONFORMITY... -
Page 8: Component Parts - General Assembly
COMPONENT PARTS - GENERAL ASSEMBLY... -
Page 9: Environmental Protection
COMPONENT PARTS-GENERAL ASSEMBLY Description No Description Front wheel Circlip 20mm Locating screw Washer M16 Idler roller Nut M16 Chassis frame Washer 12 mm Rear castor assembly Upper handle Lifting arm shaft Locating pin Circlip 25mm Screw M5x12 Handle sleeve Washer M10 Lower handle Bolt M10x 25 Pump assembly... - Page 10 COMPONENT PARTS - HYDRAULIC PARTS Description No Description Snap ring Steel ball 6dia G16 O-ring 37.5 diax2.65# O-ring 8 dia x 1.8# Retaining ring Oil drain valve stem O-ring 29.8 dia x 3.1# Copper washer# Piston rod Hydraulic valve body Retaining ring O-ring B# Piston rod head...
- Page 11 COMPONENT PARTS - HYDRAULIC PARTS...