Subscribe to Our Youtube Channel
Related Manuals for Clarke CTJ2500QLG
Summary of Contents for Clarke CTJ2500QLG
- Page 1 2.5 TONNE GARAGE JACK Model No: CTJ2500QLG PART NO: 7621802 OPERATING & MAINTENANCE INSTRUCTIONS GC03/12...
-
Page 2: Specification
Please note that details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety Precautions
1. Check the jack for damage before use and do not use if damaged. If in doubt, DO NOT use. Consult your local dealer. 2. ALWAYS use spare parts supplied by Clarke International. Using non- standard parts could be extremely dangerous. -
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY 1. Remove the retaining clip, by Handle Groove pressing the handle mounting Mounting downwards and releasing the clip from the base of the jack and Thumb from the handle opening. Screw 2. Undo the thumbscrew until the Retaining lower handle can be inserted fully Clip... -
Page 5: Maintenance
5. Take care that no obstruction prevents a clean lift. Keep all personnel at a safe distance before pumping the handle to lift the vehicle. NOTE: The jack may move slightly during operation. It is important therefore, that the floor is clean and completely free from debris. 6. -
Page 6: Oil Replacement
• The oil should be almost level with the bottom of the oil filler hole. • Oil can be topped up using Clarke Hydraulic Oil (p/no 3050830 for 1 litre). OIL REPLACEMENT 1. With the jack lowered, remove the cover plate and the filler plug. Tilt the jack onto its side and drain the old oil into a container. -
Page 7: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 8 GENERAL COMPONENT PARTS t s i c i l t i l t f i e l l When requesting replacement parts, please quote the prefix; HACTJ2500QLG, followed by the number listed above. Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 9 GENERAL COMPONENT PARTS Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 10: Environmental Protection
HYDRAULIC COMPONENT PARTS ENVIRONMENTAL PROTECTION One of the most damaging sources of environmental pollution is oil products. Never throw away used hydraulic oil with domestic refuse or flush it down a sink or drain. Collect any hydraulic oil in a leak proof container and take it to your local waste disposal site. - Page 11 HYDRAULIC COMPONENT PARTS t s i n i l n i l n i l n i l n i l c i l When requesting replacement parts, please quote the prefix; HACTJ2500QLG, followed by the number listed above. Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the CTJ2500QLG and is the answer not in the manual?
Questions and answers