Related Manuals for Clarke CTJ2000A
Summary of Contents for Clarke CTJ2000A
- Page 1 2 TONNE ALUMINIUM QUICK-LIFT GARAGE JACK Model No: CTJ2000A PART NO: 7623060 OPERATING & MAINTENANCE INSTRUCTIONS GC12/11...
-
Page 2: Specification
Please note that details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety Precautions
1. Check the jack for damage before use and do not use if damaged. If in doubt, DO NOT use. Consult your local Clarke dealer. 2. ALWAYS use spare parts supplied by Clarke International. Using non- standard parts could be extremely dangerous. -
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY 1. Remove the retaining clip , by Handle pressing the handle mounting Groove Mounting downwards and releasing the clip from the base of the jack and from the handle opening. Thumb Screw 2. Undo the thumbscrew until the lower handle can be inserted fully Retaining into the handle socket. -
Page 5: Maintenance
2. Remove the oil filler plug on the top of the ram assembly (item 32 on page 9). A broad-bladed screwdriver is required. • The oil should be almost level with the bottom of the oil filler hole. • Oil can be topped up using Clarke Hydraulic Oil: Part No. 3050830 for 1 litre. OIL REPLACEMENT 1. -
Page 6: General Care
1. Periodically lubricate the hinges, front roller and rear castors with a light oil. 2. Store in a dry location with the arm in its lowest position. 3. In the event of damage or broken components, replacements are available from Clarke Parts & Service. TROUBLESHOOTING l l i... -
Page 7: Environmental Protection
ENVIRONMENTAL PROTECTION One of the most damaging sources of environmental pollution is oil products. Never throw away used hydraulic oil with domestic refuse or flush it down a sink or drain. Collect all the hydraulic oil in a leak proof container and take it to your local waste disposal site. - Page 8 RAM COMPONENT PARTS Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 9 FRAME COMPONENT PARTS Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 10 FRAME COMPONENT PARTS t f i t i l t i l c i l Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the CTJ2000A and is the answer not in the manual?
Questions and answers