Table of Contents
Advertisement
Maintenance
Upgrading the firmware
The firmware installed in the fixture can be identified in two ways:
•
When powering on the fixture, the display shows the current installed firmware version
•
Going to the MENU → INFO → SOFTWARE VERSION
We recommend that the fixture's firmware is always up-to-date. The latest firmware version is available for download under the
respective product at www.sgmlight.com.
To update your P-6 with the latest firmware use an SGM USB 5-Pin-XLR uploader cable (available from your nearest SGM dealer)
and a Windows-based computer with the SGM Firmware Tool software installed (also available for download at www.sgmlight.com).
Additionally, the Firmware Tool software offers a simple DMX controller featuring 512 DMX channels for test purposes.
Cleaning
SGM luminaires with IP66-rating do not need any cleaning procedures inside the fixture. However, cleaning the front lens may be
needed to achieve the maximum light output after exposure to dust, sand, or dirt. Exterior housing can also be cleaned to get a better
look. To maintain adequate cooling, fans must be cleaned periodically.
Whenever necessary, clean the P-6 using a soft cloth dampened with a solution of water and a mild detergent. Do not use products
that contain solvents, abrasives, or caustic agents for cleaning, as they can cause damage to both hardware, cables, and connectors.
The level of cleaning required will vary greatly depending on the operating environment and installation. Therefore, it is recommended
to do frequent check-ups the first few weeks of operation to see how often cleaning is necessary.
Figure 15: SGM Firmware tool
15
Advertisement
Table of Contents
