Table of Contents
Advertisement
Safety Warning and Cautions
Notes on portrait installation
A dedicated mount is required for portrait installation. Contact a
professional and prepare the mount.
Attention
• Plan so that the mount does not fall.
• Use commercially available M6 screws (up to a depth of 12 mm) to fix the
ceiling mount fixing points of the projector and the mount at four points
(you do not need to remove the feet of the projector).
Attention
• Make sure you install the projector with the air intake vent facing down. If
the air intake vent is facing up, the projector does not cool down correctly,
and it may cause a malfunction.
Angle of tilt
Using the projector at angles not shown in the illustrations above may
damage it or cause an accident.
• Make sure that you install the projector with the air intake vent facing down
and that there is a gap at least as wide as shown in the following illustration
between the projector and the floor and so on. Make sure there is a gap of
400 x 200 mm for the base so that the air intake vent is not blocked.
• Once installation is complete, make sure you set the Direction. If it is not
set, the projector does not cool down correctly, and the lamps may
deteriorate.
s "Setting the direction"
p.28
• Do not use lamps that have been used for about 2000 hours or more at
normal installment. This may cause the projector to malfunction or cause the
lamps to deteriorate.
6
Advertisement
Table of Contents
