Epson EB-G7905UNL User Manual page 157

Batch Setup
c
While holding down the [Menu] on the remote control or the
control panel, connect the power cord to the projector.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power Status
Blue - On Blue - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
• Do not disconnect the power cord from the projector while the
settings are being written. If the power cord is disconnected, the
projector may not start correctly.
• Do not disconnect the USB flash drive from the projector while the
settings are being written. If the USB flash drive is disconnected, the
projector may not start correctly.
Lamp Temp
Orange - On Orange - On
d
When writing completes normally, the projector enters standby
status.
Blue - On
When the projector is in standby status, remove the USB flash
drive.
Power
157