Epson EB-G7905UNL User Manual page 168

Reading the Indicators
Indicator
Power Status Lamp
Blue -
Status Status
Flashing
varies varies
Orange -
Blue - Status
Flashing
Flashing varies
Orange -
Blue - On Status
Flashing
varies
Cause
Temp Filter
High Temp Warn‐
ing
Orange -
Status
Flashing
varies
Replace Lamp
Status Status
varies varies
Installation posi‐
tion warning (non-
support position,
Status Status
installation angle)
varies varies
This is not an error. However, if the temperature rises too high again, projection stops automatically.
Check the following two points.
• Check that the air filter and air exhaust vents are clear, and that the projector is not positioned against a
wall.
• If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s "Cleaning the Air Filter" p.189
s "Replacing the Air Filter" p.195
Replace it with a new lamp.
s "Replacing the Lamp" p.192
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may
explode increases. Replace it with a new lamp as soon as possible.
A message is displayed, and projection stops automatically after about five minutes. Check the installation
angle of the projector.
• Check the guaranteed operating range.
s "Warning and Cautions on Installation"
• Check if Direction in the Configuration menu is set correctly.
s "Setting the direction" p.28
Remedy or Status
p.3
168