Table of Contents
Advertisement
Problem Solving
Problems when Projection Starts
The projector does not turn on
Check
Did you press the [
] button on the remote control or control
panel?
Are the indicators switched off?
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
Is the Control Panel Lock set to Full Lock?
Is the correct setting for the remote receiver selected?
Was the power cord plugged back in or was the breaker turned on
immediately after direct power off?
Is the [ID] switch on the remote control set to On?
Are the lamp cover and lamps installed correctly?
Press the [
] button to turn on the power.
The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
Check that your electrical outlet or power source is functioning correctly.
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Press the [
] button on the remote control. If you do not want to use Control Panel Lock, change the setting to
Off.
s "Control Panel Lock"
p.128
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.138
When the operation to the left is performed when Direct Power On is set to On, the power may not turn back on. Press
the [
] button to turn on the power.
When the switch is set to On, you can use the remote control to operate only a projector with a matching ID. Set the [ID]
switch to Off.
s "Setting the remote control ID"
p.42
If the lamp or lamp cover is installed incorrectly, the projector cannot be turned on. Check how it is installed.
s "How to replace the lamp"
p.192
Remedy
183
Advertisement
Table of Contents
